Ultrasensitive electrochemical immunosensor based on dual signal amplification process for p16(INK4a) cervical cancer detection in clinical samples.

The p16(INK4a) (p16) is a cyclin-dependent kinase inhibitor, which has been evaluated in several studies as a diagnostic marker of cervical cancer. Immunostaining using p16 specific antibody has confirmed an over-expression of p16 protein in cervical cancer cells and its association with disease progression. This article reports an ultrasensitive electrochemical immunosensor for specific detection of p16 and demonstrates its performance for detection of solubilized p16 protein in cell lysates obtained from patients. Sandwich-based immunoreaction couple with double signal amplification strategy based on catalytic enlargement of particle tag was used for high sensitivity and specificity. The conditions were optimized to create an immunoassay protocol. Disposable screen-printed electrode modified with capture antibodies (Ab1) was selected for further implementation towards point-of-care diagnostics. Small gold nanoparticles (15 nm diameter) conjugated with detection antibodies (Ab2) were found to better serve as a detection label due to limited interference with antigen-antibody interaction. Double signal enhancement was performed by sequential depositions of gold and silver layers. This gave the sensitivity of 1.78 µA mL(ng GST-p16)(-1) cm(-2) and detection limit of 1.3 ng mL(-1) for GST-p16 protein which is equivalent to 0.49 ng mL(-1) for p16 protein and 28 cells for HeLa cervical cancer cells. In addition to purified protein, the proposed immunosensor effectively detected elevated p16 level in cervical swab samples obtained from 10 patients with positive result from standard Pap smear test, indicating that an electrochemical immunosensors hold an excellent promise for detection of cervical cancer in clinical setting.

Performance improvement of zinc oxide photoanode-based dye-sensitized solar cells by multi-walled carbon nanotube.

Unique electrical and surface-to-volume properties of carbon nanotubes have made these conductive molecules highly attractive in many applications. In this work, the influence of multi-walled carbon nanotubes into a zinc oxide active layer of dye-sensitized zinc oxide solar cell has been investigated. With this method, a significant improvement in the performance of the solar cell has been achieved. Compared to the typical zinc oxide photoelectrochemical cells, the photocurrent-voltage characteristics of the fabricated cell containing 0.05 percent by weight of carbon nanotubes in the metal oxide film displayed a higher short-circuit photocurrent, consequently caused an increase of the solar-to-electricity conversion efficiency by a factor of approximately 1.4. Further increase of the conductive carbon material resulted in a decrease of the energy conversion of the photovoltaic cell. The enhancement of the energy conversion at this optimum carbon nanotube loading may be attributed to the dye-adsorption ability and the electrochemical activity of the composite photoanodes. The fabricated photovoltaic cells with the highest efficiency exhibited the maximum dye adsorption intensity and the minimum charge transfer resistance, as measured by ultraviolet-visible spectroscopy and electrochemical impedance spectroscopy, respectively.